rynoabri12cb02a9
New member
- Joined
- Aug 26, 2021
- Messages
- 1
I have just replaced an old motherboard with the B460M PRO-VDH and now it will not get to the BIOS boot sequence.
After powering ON, the motherboard EZ Debug LED indicator goes thu CPU and RAM, but stays at the VGA selection.
I have cleared the BIOS with setting the JBAT1 and left the battery out for 10 minutes. Same happens when I switch it back on.. any suggestions what could be wrong?
Thanks!
Ryno
After powering ON, the motherboard EZ Debug LED indicator goes thu CPU and RAM, but stays at the VGA selection.
I have cleared the BIOS with setting the JBAT1 and left the battery out for 10 minutes. Same happens when I switch it back on.. any suggestions what could be wrong?
Thanks!
Ryno