Connect CoreLiquid K360 to RGB Hub on Velox 100R

[chrisgulfne15bc02e6]

So I am nearly finished building a gaming PC for my son. Just waiting on a couple things. Can't seem to figure out how to connect the CoreLiquid K360 to the extra Male 3 Pin Connectors on the RGB Hub that comes on the Velox 100R. Of which there are 4 each that have rubber covers on them to protect them if not used. As well as 1 Male 3 Pin that comes off the RGB Hub itself. If I disconnect the 3-1 splitter that comes with the K360, it doesn't work because the male to female isn't compatible. I don't remember exactly but the jist of it is when comparing the female ends, 1 set is recessed farther back in the connector so when you try to plug one of the extra male 3 pins off the RGB Hub, they barely even touch. My reason for wanting to do this is so the K360's 3 RGB fans would match the rest of the Velox 100R's pre installed 4 RGB fans and function with the mystic light button on top the case. Any ideas ? Thanks for any help.

 

[keith3_16]

So I am nearly finished building a gaming PC for my son. Just waiting on a couple things. Can't seem to figure out how to connect the CoreLiquid K360 to the extra Male 3 Pin Connectors on the RGB Hub that comes on the Velox 100R. Of which there are 4 each that have rubber covers on them to protect them if not used. As well as 1 Male 3 Pin that comes off the RGB Hub itself. If I disconnect the 3-1 splitter that comes with the K360, it doesn't work because the male to female isn't compatible. I don't remember exactly but the jist of it is when comparing the female ends, 1 set is recessed farther back in the connector so when you try to plug one of the extra male 3 pins off the RGB Hub, they barely even touch. My reason for wanting to do this is so the K360's 3 RGB fans would match the rest of the Velox 100R's pre installed 4 RGB fans and function with the mystic light button on top the case. Any ideas ? Thanks for any help.

As far as I'm aware you can not do that, as they are supposed to be connected to a motherboard. I could be wrong, but that's how it is with my MAG CORELIQURD 240R, and the RGB from the fans are not compatible with the RGB hub on my MAG Forge 100M

 

[teletubby_po]

can you connect the AIO cooler fans to the 3 to 1 splitter, and connect it to the RGB hub?