Cubi N ADL-037 how install additional ssd 2.5

[avroracalybr156002d6]

Hi all.
Two questions.
1. I installed a 2.5 ssd drive, but I'm not sure if I placed the wire correctly. The wire is located very tightly between the m.2 ssd and the 2.5 ssd. Is everything correct or should it be different?
2. What is this connector (JESPI1) for?

 

[badboy2k]

Hi all.
Two questions.
1. I installed a 2.5 ssd drive, but I'm not sure if I placed the wire correctly. The wire is located very tightly between the m.2 ssd and the 2.5 ssd. Is everything correct or should it be different?
2. What is this connector (JESPI1) for?

View attachment 185777View attachment 185778
View attachment 185779

1: that looks Correct its tight as the connector is under the M.2 position as its a very Tight Layout and was the only real place they had room to put it.
2: JESPI1 is a connector that is used in the Factory to Flash the BIOS and Program some of the Chips Firmware its not for end user use

 

[bitfidelit151202d6]

Does anyone have a clear photo of this cable? Or, better yet, its part number? Because I had MSI Support send one, and they ended up sending a regular SATA and power cable instead..

 

[badboy2k]

Does anyone have a clear photo of this cable? Or, better yet, its part number? Because I had MSI Support send one, and they ended up sending a regular SATA and power cable instead..

Near Impossible to get a Good Image of it but send them another Support Ticket and ask for one for a Cubi N ADL with this Pinout on the Connector and they should send you the Correct one: