Disable onboard LAN on P67A-GD65-B3

krylonx

New member
PRIVATE E-2
Joined
Jun 30, 2011
Messages
3
Can anyone else confirm the following two symptoms?    I've tried the last 3 BIOS releases as well as 2 identical motherboards and all of them are affected.

If you disable the onboard LAN, two things happen:

1. You can no longer boot from a Memtest86+ CD.  It hard locks the PC during the Memtest86+ loading screen.
2. You get an error message that flashes up during the POST process that states: PXE-E01: PCI Vendor and Device IDs do not match!
 
If you disable the onboard LAN, two things happen:
2. You get an error message that flashes up during the POST process that states: PXE-E01: PCI Vendor and Device IDs do not match!
With the Lan Controller disabled, it seems to be related to how the 6 series chipset operates in some way. Until a newer BIOS revision, the Z68-GD80(B3) if either Lan is disabled, it lost PCI function. If #1 is disabled, PCI does not work, #2 also did not work. Now, with a BIOS revision, #1 enabled will work & PCI works. Disable #1 & enable #2, #2 Lan port works but PCI is again disabled. Conclusion, a BIOS revision seems to be able to address this, so recommend a ticket to MSI Tech Support concerning this right away. Currently, I don't have the P67 hooked up, but I can test it out later & see if it also has this behavior with the Lan disabled since it only has one port instead of the two on the GD80. http://support.msi.com/

Just realized I don't have a PCI device connected in the P67, all PCI-E. :bonk:
 
HU16E said:
With the Lan Controller disabled, it seems to be related to how the 6 series chipset operates in some way. Until a newer BIOS revision, the Z68-GD80(B3) if either Lan is disabled, it lost PCI function. If #1 is disabled, PCI does not work, #2 also did not work. Now, with a BIOS revision, #1 enabled will work & PCI works. Disable #1 & enable #2, #2 Lan port works but PCI is again disabled. Conclusion, a BIOS revision seems to be able to address this, so recommend a ticket to MSI Tech Support concerning this right away. Currently, I don't have the P67 hooked up, but I can test it out later & see if it also has this behavior with the Lan disabled since it only has one port instead of the two on the GD80. http://support.msi.com/

Just realized I don't have a PCI device connected in the P67, all PCI-E. :bonk:

I can confirm that with this board, PCI and PCI-E is not affected by disabling the NIC.
 
Try a full clearing of CMOS. Power off, power cord removed from the PSU, discharge the caps, remove the battery for awhile, reset & try again & see if the error message then goes away.
 
Both problems go away as soon as you re-enable the onboard NIC.  The error message is no longer displayed and you can then launch Memtest86+ from a disk.    Can anyone else confirm?
 
Back
Top