GeForce3Ti200 TV Out Problem

R

RandomNameGuy

Guest
I am able to switch the video output from my monitor to my TV, but I'm not able to get both devices to display a picture at the same time! I don't have a twinview tab under display properties (like the book says I should have), so I can't use that to enable the clone feature. Any ideas?
 
Sort by date Sort by votes
As far as I know geforce 3 can't display two things at once.
The twinview tab is only activated with the geforce 2.
 
Upvote 0 Downvote
Thanks...that would explain it. Nice of the company not to adjust their manuals to reflect the actual piece of hardware they're selling...
 
Upvote 0 Downvote
My manual did state that its for MX series only. But you did have to read it properly. I swear I read that section about 10 times word for word wondering where my beloved twinview was before it clicked home...
But seriously, if we desparately wanted twin view we would have bought a Matrox
 
Upvote 0 Downvote
TRY TV TOOL !!

BUT (yeah theres a BUT)

1)you have to set desktop to 800x600

2)TV-TOOL isnt free and will only give you 15 mins of use at a time.

Warning: i only tried it on my MSI GF3 ti 500 ;)
 
Upvote 0 Downvote
Does Tvtool work like twinview? All I got was test strips on tv until I switched over.
Or do you mean monitor set to 800X600 for twinview to work.
Tvtool does rock. Good config like on old mx and only one button to change to TV
(would test again but just fin redoing system)
 
Upvote 0 Downvote
The philips saa7108 tv encoder chip is not supported twinview...
Tvtool set only dual view....

twinview is only gef 2 Mx or gef 4.....
 
Upvote 0 Downvote
Back
Top