Monitor keeps turning on and search for signal

[huiting159102db]

Hello,

My monitor keeps searching for a signal when the computer and monitor are turned off.
Within a few seconds after turning the monitor off it shows "no DP signal" on the screen and will repeat that every time.
In the monitor settings the automitic scan function is turned off in the source menu.

What else can I do except from unplugging the monitor from the power.

 

[fauc]

It is normally.
Because system is turn off and monitor cannot detected signal from DP port so it will be showed this message-"no DP signal" on monitor.

 

[huiting159102db]

It is normally.
Because system is turn off and monitor cannot detected signal from DP port so it will be showed this message-"no DP signal" on monitor.

Ok when I turn off my computer I can understand it but when I turn off the monitor I don't understand it.
It keeps cycling when the monitor is turned off
Power off --> power on --> no signal --> power off all in about 10 seconds and it never stops unless I unplug the power cable from the monitor.

 

[badboy2k]

Ok when I turn off my computer I can understand it but when I turn off the monitor I don't understand it.
It keeps cycling when the monitor is turned off
Power off --> power on --> no signal --> power off all in about 10 seconds and it never stops unless I unplug the power cable from the monitor.

are you sure your not putting it into standby? usually Monitors have 2 modes they can do VIA the single power button. usually a single quick press will just put it into standby and holding it for 5-10 seconds will shut it off.

 

[huiting159102db]

After the problem with the cable I could do a firmware update and the problem is solved.