Tech-Support Msi z690a pro ddr4 Bios Boot Loop

Troubleshooting

Daggeringmaster876

New member
Joined
Oct 14, 2026
Messages
3
I just build my first pc and was doing a practice start up but every time it gets to around the three minute mark my pc restarts. Is it normal for my pc to loop even with green light on motherboard?
 
No. The green LED would be the BOOT LED, that's normal because you have not installed an OS yet, so it should be in the BIOS. But it should not reboot after a certain amount of time in there at all. Please list all the components currently installed, including PSU model of course.
 
No. The green LED would be the BOOT LED, that's normal because you have not installed an OS yet, so it should be in the BIOS. But it should not reboot after a certain amount of time in there at all. Please list all the components currently installed, including PSU model of course.
12600kf
Arctic liquid freezer 36
Acer Predator ddr4
1660 ti
Apevia prestige 600w
2x 128 gb sata 2.5
Msi z690 a ddr4 Wi-Fi
 
Hmm, not the best choice of PSU brand. Almost all of their models are "Tier F - Replace immediately", you are lucky that you chose the only one which might be halfway acceptable:

index.php


Given this very flaky track record, it would probably be good to test with a known good PSU, not too old and of decent quality, connected on-the-fly using its own cables. Just try to borrow another PSU and put it next to the PC with the fan unobstructed, hook up the power cables and check if the reboots stop happening.

Apart from that, another basic method of troubleshooting is to leave out what you can in order to rule it out. Disconnect the two SATA SSDs, go to only one RAM module in slot A2 (second from the left). The graphics card has to stay, since you have a -KF CPU.

The CPU cooler, is that really a "Liquid Freezer" model? Because I suspect it being the normal "Freezer 36", air, not liquid.

How confident are you that you were careful enough not to damage any socket pins before and during CPU installation? Because that can happen very easily on accident, also see here. So there, you would have to take off the cooler, take out the CPU and check the socket pins for any bent ones, and take some good photos of the socket. Because bent pins, well, they can cause any kind of weird issue. But first I'd try the other stuff, unless you can't easily borrow a PSU now.
 

Attachments

  • Screenshot 2026-10-15 014950.png
    Screenshot 2026-10-15 014950.png
    214.4 KB · Views: 169
so even in bios setup mode, the system will restart within 3 minutes every time?
Try to double check CPU temperature also and then if have chance try another VGA card, you need to check if there's a
certain peripherals causing this issue?
 
Yes, CPU overheating is also a possibility, even though I would normally expect an overtemperature shutdown then, not a simple reboot. But check the CPU temps in the BIOS, it's shown somewhere on the top, it should be below 40°C.
 
Then I'd do the other troubleshooting steps I mentioned. The main steps of troubleshooting are always to check for basic things first, like loose cables, any simple mistake, and then you want to leave out things that are not required to boot to BIOS, simplify the system as much as possible. And for the things you can't leave out, like the PSU, you would borrow a known good part for testing. Eventually you should have narrowed it down to some cause.

Also, especially since this was the first PC you built, one big chance of messing up is always involving the CPU installation and the very fragile socket pins. When some pins accidentally got bent during that, then all bets are off, there is no telling what they can cause. So this I would also check early on, taking photos of the socket and uploading them to an image hoster so we can double-check them here.
 
Back
Top