Such a basic feature that MSI Afterburner doesn't have.

8686sid

New member
PRIVATE E-2
Joined
May 10, 2017
Messages
4
When I've set a curve, when I click the dots to check what the figure is, it will (because of poor design) move slightly, there's no way to check the figure unless I click it. This is annoying. Any chance they will fix this? Can't they just show the figure when I hove over the point?
 
This also happens in the Fan Curve setting. I want to check the dots, but if I click it, it will move at the same time...
 
MSI Afterburner is developed by Russian national Alexey Nicolaychuk, who goes by the name Unwinder across tech forums. Perhaps you can find him online and offer that suggestion directly to him. Otherwise, I don't think your suggestion will reach him.
 
Back
Top