TV @NYwhere Control Prob Anyone?

J

jord_w

Guest
Hi there ppl,
I just got my tuner today and it seems to be working perfectly. The only thing wrong is that when I use the control it sends the signal twice. - ie. If I turn it on via the control, it'll turn off; or if I flip the channel it'll flip 2 times instead of one.

I think its a problem with either the receiving sensor or the control. Anyone else have this prob? Thx
 
Sort by date Sort by votes
most likely its a prob with the control. Anyone else have the same or a similar prob with their remote control? I want to see how widespread this problem is.

I really don't want to pull this card and get another one and put it back in, but I think its the only way to resolve this issue seeing the remote might be defective.
 
Upvote 0 Downvote
Got the same problem. Although I have bigger problems now. When I first installed the card the remote didn't work. Reinstalled the drivers and software again, and got it to work for a whopping total of 10mins. That's when I noticed it skipping every other channel. After that it just stopped working. So I tried another reinstall on a fresh system (W2K), and still no go. I think these remotes are defective. Don't want to return it because I find the picture quality to be pretty good compared to other cards. So any suggestions?
 
Upvote 0 Downvote
Same here minimal - in regards to returning it.

Anyhow I found another problem, I have the MSI KT333 Ultra ARU and sometimes when I turn on my system it won't POST or anything.
I looked on the D-Bracket and found out that its freezing while detecting the memory.

To make a long story short, the TV @nywhere was causing the freezing when detecting the memory regardless of what slot I put it in.

When its not in the computer at all, no freezing @ the memory detection occurs. X(
 
Upvote 0 Downvote
Back
Top