What screws do I need to use for a push/pull config with a Mag Coreliquid 360R???

blkwol152f02d7

New member
Joined
Nov 14, 2020
Messages
2
What screws do I need to use for a push/pull config with a Mag Coreliquid 360R???

I've tried these but the threads didn't take hold into the cooler. Alphacool NexXxos Fan screws M3 x 35mm
 

Nichrome

Well-known member
Global Moderator
Joined
Nov 7, 2013
Messages
19,042
Hi
Unfortunately I don't have one to check the size. You can either measure them and check in some shops or ebay, or check with MSI directly: >>How to contact MSI.<<
 

blkwol152f02d7

New member
Joined
Nov 14, 2020
Messages
2
Hi
Unfortunately I don't have one to check the size. You can either measure them and check in some shops or ebay, or check with MSI directly: >>How to contact MSI.<<
Thanks, I appreciate your response but I'm kind of blown away at how difficult this is to get an answer to my question..especially from an MSI forum. I thought push/pull was a common configuration. I've tried contacting MSI customer service and I can't get through. I tried the chat room with no help and even sent them emails. I've also contacted NewEgg without any help. I also went to my local ACE Hardware store and they didn't have the right screws. I've also checked eBay.
 

flobelix

Well-known member
Global Moderator
Joined
Jan 25, 2007
Messages
39,654
Well, this is a user to user level forum. Technical Specs can only be provided by MSI.
 
Top